|
|
|
||||
|
|
by hdzcar
I am replacing a pot with the new 1000.2 1000.4 WA since I have problems setting up satellite 129. With no obstructed views. I'm using the same settings as the 1000.2 dish and set-up using a meter $ 10.00 cheap on port 1. I get a good signal on the meter, but when I use the signal VIP722 point I can not get any signal. When I run a check switch back statellites that were not detected, I want to save or cancel so I can delete. Should I be saving the settings of control switches for the new dish? I am replacing a pot with the new 1000.2 1000.4 WA since I have problems setting up satellite 129. With no obstructed views.I'm using the same settings as the 1000.2 dish and set-up using a meter $ 10.00 cheap on port 1. I get a good signal on the meter, but when I use the signal VIP722 point I can not get any signal. When I run a check switch back statellites that were not detected, I want to save or cancel so I can delete. Should I be saving the settings of control switches for the new dish?
Special Offer www.amazon.com